Configuring Axis Camera - M2025-LE and other newer models

To capture picture in JPEGger you must make these changes.

Open the camera in a browser.

Click on SETTINGS in the lower right corner of the screen

Click on SYSTEM

Click on PLAIN CONFIG

Click on NETWORK

Find HTTP in the list on the right.  Set it to Basic.

At the bottom of the screen click SAVE

• Related Articles

• Configuring View Areas in Axis M3007 camera in Jpegger

  This PTZ camera supports multiple views.  In addition to some predefined views the camera allows the creation of View Areas using PTZ functionality.  Create the desired View Area in the camera.  Then in Jpegger, choose the Axis M3007 as the camera ...

• CONFIGURING THE DEFAULT RECEIPT PRINTER FOR NCR P86

  Configuring Default Receipt Printer Switch ATM to supervisor mode. Confirm Select Menu is displayed. Press 5 key then ENTER key. Press 8 key then ENTER key. Press 1 key then ENTER key. Configuration data is displayed. Press the ENTER key. Press 11 ...

• NETWORK CAMERAS CURRENTLY SUPPORTED IN JPEGGER

  The following network cameras are supported in JPEGger. Please note that support can be added for other network cameras provided that they have a way to retrieve a JPEG image via a browser. Please contact TranAct if you have a network camera that ...

• STAR TUP 942 – INSTALLATION & SETUP

  Please see attached documents for Installation & Setup Instructions.

• INSTALLING THE USB CROSSMATCH VERIFIER

  USB Support For The Crossmatch Verifier Was Added With Scrap Dragon Version 6.4i Do not plug in the Verifier until the USB_SDK software has been installed and the system rebooted. Download the “USB SDK for Verifier 300LC and 310LC” from the ...